How to Replace an Aqua Pure AP810 Water Filter

Filters for the Aqua-Pure AP801 and AP801-1.5 are used to address sediment, taste, rust, and odor concerns with your drinking water. The Aquapure AP810 whole house water filter removes sediment, rust, and other contaminates down to 5 microns. Depending on your incoming water quality it is recommended that you replace your AP810 filter at least every 6 months.

Steps

  1. Image titled Replace an Aqua Pure AP810 Water Filter Step 1
    1
    Turn off incoming water by isolating the Aqua-Pure system with existing valves on your homes water supply system.
  2. Image titled Replace an Aqua Pure AP810 Water Filter Step 2
    2
    Bleed the pressure from your Aqua-Pure unit by pressing down on the red button (pressure relief button) on the top of the filter housing
  3. Image titled Replace an Aqua Pure AP810 Water Filter Step 3
    3
    Take your filter wrench and slide it up from the bottom of the filter housing towards the head. Once in place turn to the left to unscrew.
  4. Image titled Replace an Aqua Pure AP810 Water Filter Step 4
    4
    Remove the housing, and wipe it clean, and then insert your new Aqua-Pure AP810 water filter.
  5. Image titled Replace an Aqua Pure AP810 Water Filter Step 5
    5
    Add a small amount of silicone o-ring lubricant (available at most hardware stores) to the O-ring and screw the housing back into the head.
  6. Image titled Replace an Aqua Pure AP810 Water Filter Step 6
    6
    Turn back on your water supply to the system.

Tips

  • Change the filter cartridge at least every 6 months. Improper installation and maintenance may result in property damage due to water leakage.

Warnings

  • Do not use with water that is micro-biologically unsafe or of unknown quality without adequate disinfection before or after the system.

Sources and Citations

Article Info

Categories: Faucets and Taps | Plumbing Drains Waste and Vents