How to Make an Airsoft "Trap" Target

Here's an easy way to make a cardboard Airsoft target that traps your pellets.

Steps

  1. Image titled Make an Airsoft "Trap" Target Step 1
    1
    Gather all of the supplies you will need. They are listed below.
  2. Image titled Make an Airsoft "Trap" Target Step 2
    2
    Assemble the box as shown.
  3. Image titled Make an Airsoft "Trap" Target Step 3
    3
    Put all four flaps down and tape shut. Flip the box and repeat on the opposite side.
  4. Image titled Make an Airsoft "Trap" Target Step 4
    4
    Lay a target on the side of the box.
  5. Image titled Make an Airsoft "Trap" Target Step 5
    5
    Draw lines on the box tracing the sides of the paper as a template.
  6. Image titled Make an Airsoft "Trap" Target Step 6
    6
    Cut along the lines.
  7. Image titled Make an Airsoft "Trap" Target Step 7
    7
    Tape the flaps on the inside down, to prevent the pellets from getting stuck.
  8. Image titled Make an Airsoft "Trap" Target Step 8
    8
    Cut a hole on the top, to let the pellets out later.
  9. Image titled Make an Airsoft "Trap" Target Step 9
    9
    Tape the target onto the big hole on the side. Ensure that it is as tight as possible.
  10. Image titled Make an Airsoft "Trap" Target Step 10
    10
    Done! Your new target should look like this.

Warnings

  • Always let an adult do the cutting.

Things You'll Need

  • A knife
  • Tape
  • A cardboard box
  • A target (you can draw your own or print one from the Internet)

Article Info

Featured Article

Categories: Featured Articles | Airsoft